[Varget Powder - hard to meter, but question]

I think gose and j28s should host the next shooting match in their area together. That could be quite an event.

On another note, given powders can be hard to find, it would be nice to have a trading forum to swap supplies.

[Best all around powder for 9mm, 40S&W and 45ACP?]

231 works for me. Just clean your gun every now and then.

[125gr Hornady SST .308 loads]

I've got some pretty sweet h4895 loads with this bullet. Standard protocol, start low and work up for your particular rifle.

[Which powder should I try to find for loading precision 308 while usin]

I've used h4895, varget, and vv n140. I've found all to meter fine with my 550 if I take my time. I have found both very inaccurate as well as very accurate combinations for my rifles with each of these powders.

[Light 308 loads]

I'm glad you made that point. I should have been more specific in my post. My understanding is the H and IMR powders despite having the same number labels are quite different. I think that is unfortunate as I think it could lead to errors. I use imr 4831 for my 270 and I have to be careful I don't use h4831 data.

[Poor Man's Brass Tumbler?]

Sorry. Should read reloaders not reloaded. Autocorrect!

[Poor Man's Brass Tumbler?]

I just wipe my brass off and so far I haven't seen a single issue with loading nor shooting. Maybe I've missed something in my reading but I've been advised by some pretty old reloaded that brass doesnt have to be shiny to operate correctly and safely. By all means correct me if I'm wrong however.

[Light 308 loads]

I'll probably start with 4895 as I've read elsewhere now that it does well with reduced charges. I'll report back with the results.

[Light 308 loads]

Thanks. I'll research the data on these.

[Why not W231 for .45 and 9mm and be done with it?...]

I've been very pleased with 231. Use it in 9, 40, 45, 38. I figure the less different powders around the less likely the wrong powder will end up in finished ammo. Dirty? Just clean your gun more often. I've learned a ton about how my firearms work just through disassembling them for cleaning.

[Light 308 loads]

I'm looking for any experience with light recoil 308 loads. I'd like to find a recipe for 125 gr bullets to be used for some small competitions as well as for youth hunting. Obviously the particular bullet might be different but I'm looking more for any powder recommendations. The only info I have found for light recoil loads is with h4895. I have plenty of varget if anyone has any experience with this powder. Thanks

[Contender 357 max]

Thanks graham. I'll contact Thompson.

[Contender 357 max]

I don't know what open uspsa is. I'm new to the forum. I started using this forum to learn more about reloading so I can do more shooting and possibly enter some contests. Where is the appropriate forum for this question? This forum is named open pistols. Sounds like a forum you can post pistol questions in. Thanks.

[Contender 357 max]

I've read you can shoot 38 special as well as 357 mag in a 357 max 10 inch contender barrel. Some say you should not do it however due to it somehow damaging the barrel. I'm looking for first hand input. Anyone out there have this barrel and shoot 38 specials. I want to use the max for hunting but the 38 for fun plinking as I have a ton of 38 light loads. Thanks.

[357 max scope vs red dot]

I might try the millet. I'd go $200 or so if needed. I just don't want to go real high dollar as I've never used a red dot and am not sure if I will even like it or not for hunting.

[357 max scope vs red dot]

I've decided on a red dot. But I can't decide on which one. I want to keep the cost down. I can't figure out which red dots will hold up to recoil of a large caliber handgun. Any suggestions on specific brands and models?

[357 max scope vs red dot]

I've never used a pistol scope. 2x, 4x? I understand the more magnification the harder it is to acquire the target.

[357 max scope vs red dot]

I have a contender with a 10 inch (I think) barrel in 357 max. I want to try hunting with it this year for hogs and deer. Most shots are probably 50-100. Trying to decide on whether to put a scope on or a red dot. Any suggestions? Any experience with this caliber? Amy input Is appreciated!

[Glock 19 reduced spring]

I have a glock 19. I believe the factory recoil spring is 18 pounds. Correct me if I'm wrong. I'm shooting reduced power loads but gun isn't cycling properly. My guess is the spring is too heavy. Any recommendations on spring weight to change to?

[357 max hunting load]

Thanks. I'll give the above suggestions a try.

[357 max hunting load]

Looking for a good hunting load to work up for deer/hogs this fall. I rarely have to shoot beyond about 50 yards. Any load suggestions? I have some Hornady xtp 158gr bullets already but I don't mind getting something else. I have plenty of lil'gun which I use for 357 mag as well but can certainly get different powder if suggested. Will be shooting from 10 inch Thompson contender. Thanks.

[Glock 19 barrel replacement]

Thanks John. That's the info I'm looking for. I love the feel of my glock but whether real or not, I've been scared to shoot lead through it after reading about the kabooms. I figure 100 bucks is worth the peace of mind.

[Glock 19 barrel replacement]

Any particular reason why?

[Glock 19 barrel replacement]

Not sure which forum to ask this but I need to change the barrel on my glock 19 as I reload lead. Anyone have any experience with Lone Wolf barrels? There is one for 99$ at midway. I don't mind paying a bit more but why pay more if the cheaper one works just as well. Any thoughts?

[147gr LRN and 231 or bullseye]

Mike P, do you know what lb spring the 9 mm glocks usually come with? Also, sounds like I need to try some slide glide.