slamm

Right now it is running better with the 14lb zev than with the 11lb carver. I agree with you and don't thnk this makes any sense. I appreciate the advise and expect changing the angle of the ejection port, and replacing the ejector. I think I will wait and see if I can get a reply out of Bobby Carver before I modify anything else.

Sent an email to Bobby Carver also

Tod_p. I will pm my email address Gunnator. You are correct it is flat. I understood that was how it should be however it could explain the issues. Was your port lowered by carver or SJC?

Thanks pizzim

OK range report from today Note using factory minor pf rounds I have lowered the ejection port to .239-.245 average Have tried a carver captured 11lb guide rod and spring Fells heavier than my dev 14lb Also zev 14 lb and lighting 14lb cut about 40% off of the lighting and the gun started to cyle about 3-7 rounds before jam Also flied the 15 degree angle on the ejector After the ejector mods I can run 3-4 rounds with the zev 14bl spring Pictures added I will be ordering the carver extended ejector on monday PIcs as requested (i am new member and it will not allow me to add links

Thank you for the reply. I will post pics when I get Back from the range. Ejection port is just above the serial number. Can you provide more info on the bearing you are talking about I have a fulcrum ultimate in the gun however I did file the ejector maybe it is to short now. Thanks for your help

Looking for help from anyone who has built an open glock with the SJC mount. I have lowered the ejection port quite a bit and still have ejection problems. The cases are trapped sideways in the breech open end facing out. I am running a carver captured 11lb spring and guide rod lonewolf barrel and carver 3 port comp. Any advice would be appreciated