sigpros

That could be the problem. I have only been using a case in the seating die. Thanks for the help guys

I chronoed them at 850fps last nite. And the guy thought I had just a hair too much crimp. I am going to back it off and bump the charge up a hair

The mags are almost new. 100 rounds maybe put in each. And never a problem with factory ammo. You are seating deeper that me should I go a lil lower? And I think you are 100% on the strokes. Don't think I was doing them even

Finnally got the Dillon set up. And loaded 50 rounds. My OAL is jumping around a little. from 1.155 to 1.163? Do I need to trim my pistol brass? Also was using the 3.2 grains of titegroup. Load is real accurate but it won't lock the slide back on an empty mag. And I had a couple of short strokes. So Do I need to bump the charge up tenth or two? Or seat a bit deeper? Thanks for the help

I'm in Smithville.

Thanks guys. I have been down trying to get the dillon set up. It has been years since I loaded any pistol ammo. It was set up for 45 acp. Switching it all to 9mm now. I will be sure to load some up with your loads. Thanks again guys

Hi all. New guy here. Started shooting IDPA a few months back and really like it alot. Would love to get into 3 gun sometime. Great site and I am learning alot

Hi new guy here. I have been shooting IDPA for a few months now and have deceided to start reloading for it. I had bought some supplies and had some load data but I moved and I can't find my load data. I have done a search and found some stuff but it wasn't quite the same componets that I have. So here is a list of stuff I have and see if you guys can help find a load to get my press set up with. I am using a dillon 550B and I don't have a chrony. Thanks Chris 5K tula sm pistol primers 1K federal sm pistol primers 1K Berry's 147gr RN bullets 1lb Titegroup 1lb Silhouette 10k mixed range brass