Peter S Welling

I have a Beretta Extrema A391 I would like to get set up for 3 gun. Just weld the lifter and open up the loading port. And also some other fluff and buff work. Does anybody know of a good gunsmith that will work on Beretta? I've tried several smiths and they just work on the Benelli's. Thanks!!

Bolt carrier is clean, Ive been using Rio's for over a year and have been extreamly reliable, but I did just pick up a new case. So I will try to run some different ammo through and see if I get the same result. I will check for trash under the extractor....thanks for the advice! P.S Wish I could make the 3gun this weekend Frank.....too much night work this week and need to get work done around the house and garden!

Has anybody ever seen this happen? At last weekends 3gun it started doing this. Its funny cause I just cleaned it after about 2k rds. Out of 30 rounds, about half was torn. The others were dented pretty good. Im running Rio 2 3/4 1 1/8 8 shot. It still runs just tears up the brass.....Any ideas?