RLW

Not sure if they are interchangeable or if you can vary the speed of the 1200rpm motor. What I did was I purchased variable speed motor from the same company that PW gets them from(cost me a fortune). It was a bigger motor (fortunately had the same size shaft) so I had to do some cutting and drilling to mount the thing to the PW mount. It will run from 120 rounds per hour to 2880 rounds per hour. on my machine, it seems that I run into problems going over 2200-2300 round per hour. I figure with some tinkering and the fact that I just got a casepro I could probably get it running a tad faster, but I am not sure it is necessary. it is really nice when something is not quite right I can slow it way down and check things out.

I contacted Mike about one Sept 20th. He called me to get my payment info yesterday and he said it would be shipped out this week. Ryan

Ok, I emailed Mike and he does make a die for the 223. I will be getting one with my Casepro.

Also, can someone explain the photo where the .223 cases are being sized by a 9mm die?

When did you get the casepro, and how long did you have to wait? I have been waiting for 4 months. I have emailed a couple of times, and always get a reply that he is trying to get parts and that I am on the list. Also, if you don't mind me asking, what is the current price? I have never been contacted to place my order, so I have no idea what the price currently is. Ryan

Never timed it , but less than 3 minutes Dillon 1050 with mr. bullet feeder and PW autodrive that I swapped out the motor on with a variable speed motor that will run between 120 and 2880 cycles per hour. I can only run it at about 2400 per hour with the 9mm before I start spilling powder all over the place. At 2400 I think that comes to around 2.5 minutes for 100 rds. I just recently set it up with a vibratory primer feeder that feeds primers into the primer tube. I have not used it with the feeder yet as I don't have supplies for a few more weeks, but I did turn the press on to simulate the movement and primers seemed to feed no problem. I will post in a few weeks when I get supplies and give it a go.

precision delta has 115gr $70 per 1000 shipped