ohdsmith

YES, you are correct... However it was a cumbersome design to facilitate the longer Railmount C-More sight... I feel that C-More has not been forthcoming on the new Short Tactical Sight and the STS mounting solutions but may be in the process of dumping their older rail mount C-More and the long 2 pc supporting rail mounts, to the miss-informed...

Ouch...I wonder if I should just eBay my new Burris... another $210.oo loss This seems to be a trip-foward by trip-foward installation.... RHT has sent me this photo of the top. Now I need to check with BURRIS for compatibility NOTE: The picture shown is of a 3 Hole Installation... The Tanfoglio 4 Hole Pattern is was available to me...

THANK YOU SOOOOOO MUCH.. .. I place an order with them tonight.... It's the NEW STS mount...BUT...WHY haven't C-MORE and Tanfoglio made it available to their $1000.oo Witness Hunter customers...This experience cost me $140.oo not to mention 3 days of research...

I tried that also...But..the sight is then exposed to barrel blast...also... these mounts seem to have a built in 1 deg. slope (why, I dont know) To say the least, I have sent eMail to both EAA and C-More complaining on their failure to provide a up front information for the new STS mounting solutions for the Tanfoglio...

NO... You are looking at the long side of the bridge mount on the cammo gun vs short... Note it reaches the rear sight... not to mention it overhangs the open ejection port... NOW with that clarified, My purpose is to find a modern mount for the AEE Witness Hunter frame w/4 holes to carry my STS Type Red Dot Sight...

NO its correct... As stated, I installed only the right half of the 2 pc mount w/ Weaver Rail...(its the short side)... The left half serves no purpose as it extends almost over the rear sight...The EAA Bridge Mount was designed for the C-MORE rail mount... see pictures... one of another Witness Hunter showing the long left side of the 2 pc bridge mount... note the short SIG scope on the long weaver rail sitting on a longer than necessary mount...the other picture of the Weaver rail mount, a waste of my $140.oo for this obsolete device...

Thanks...I have just copied them...

THAT is the ticket! Problem I see with a G22 frame vs. the CZ is drilling into polymer isn't really a solid solution to mount with screws. Maybe like a Carver mount, but much lighter weight (with no rear torque arm) and a super-low platform for a Jpoint in the same location would be a perfect solution. PLEASE ADVISE ME OF THE MAKER OF THE MOUNT (BRIDGE) I NEED ONE... THANKS OHDSMITH@AOL.COM

PLEASE ADVISE ME OF THE MAKER OF THE BRIDGE FOR THE RED DOT SCOPE....THANKS OHDSMITH@AOL.COM

I have endeavored to mount my Witness Hunter 6" 10mm with a Short Tach Sight STS... The Tangfoglio advertised mount is a bridge w/ weaver rail with 4 pre-drilled holes on each side spaced at 1mm apart... It was 3 times longer than the Burris sight... Problem is, it overhung the ejection port... I reinstalled it using only the right half of the 2 part full bridge (left side being much shorter).. It works, (but to say the least, this is a poor fit)...I looked elswhere, and found a Arredondo J. Point Doctor Sight Pistol Mount that looks to be the answer.. HOWEVER.. Here again I am without complete info from the manufacturer ie: NO DIMENTIONS, USER FEEDBACK, or an eMail address to consult with the supplier as to its fit and/or usability... OUCH!!!!