Jump to content
Brian Enos's Forums... Maku mozo!

Jimmy76

Classified
  • Posts

    51
  • Joined

  • Last visited

Posts posted by Jimmy76

  1. We had our match this past Saturday and ended up using a 2"x2" drove in the ground. Painted it bright orange and it measured 24" tall from grade. Hope this helps someone. 

     

    Special thanks to Zack for providing a lot of support to make our match a success!

     

    Jim

  2. Hello all, my 12 son is wanting to start participating in multi-gun and I would appreciate others opinions on shotguns for junior shooters. He's been shooting Steel Challenge and USPSA for a few years and enjoys it. We have youth model pump action 20 gauges to get started but what's some good semi-autos to look into? I'm open (pun intended) to open shotguns with comps too. 

    Thanks

    Jim

  3. Hello, I want to share a positive experience I had with Double Alpha customer service. 

    The hangar for my magnetic magazine pouch broke and I inquired to DAA about purchasing a replacement. When a package arrived from Europe, I found not one but two hangars inside, complimentary.  A great example of customer service and a commitment to shooters. I will continue to buy and use equipment from a company that supports their customer base.

    Thanks DAA!

    Jim

     

     

  4. Another fan of the 320 here. I replaced my M&P .45 compact with a Sig P320 9mm compact for everyday carry. I wanted to switch to 9mm for more ammo capacity. Much better stock trigger and ergonomics. Only complaint is the location of the slide lock lever as its further back on the frame and my strong hand thumb rides on it. Minor grip adjustment and all is well. Very accurate with Hornady Critical Duty 135 gn ammo. I went with a local holster maker for an IWB kydex holster. Really wanted a Comptac Infidel holster like I've used for years but they're not available yet.

    Jim

  5. I'm having the same issue. Talked to Dillon CS and its hard to troubleshoot since its sporadic. Only happening for 9mm on my 650, no problems at all when loading .40.

    Using Dillon dies and doesn't happen on a particular shell plate hole. I've made sure the shell plate is clean without any powder in the grooves and doesn't matter if the shell plate is full or not. When the shell plate is raised up, I have to push the brass into the sizing die a little by hand when it doesn't go far enough under the resizing die. Tried a friends case insert slide and slide cam and that didn't seem to help either. I may buy a different tool head and see if that helps.

    Hopefully someone can chime in for some help.

×
×
  • Create New...