Trying to get my press dialed in to load .40 and I'm running into an issue. I bought a Mini Mr. Bulletfeeder for my 550, which required going to a single station RCBS taper crimp seater die. My gun is a G35 w/ KKM barrel and I've got some pictures but it wont let me post them.
Anyways, what I'm running into:
1) Factory Remington UMC round in chamber seats completely and has a slight amount of play.
2) My own load at 1.15 OAL with a Gateway .40 bullet (.401 diameter) does not chamber completely by dropping it in. If you compare them side by side it is like my round sticks out of the chamber ~1/32" of an inch or so.
The pistol will go into battery when testing with the round but it is extremely difficult to rack the slide to eject the round and obviously is not right.
Lastly one other test that I did is run an empty case through the last stage on the press to make sure that the flare on the case is gone. Without a bullet, it drops into the barrel without issue and behaves exactly like the UMC round. I've attempted to load to different OAL and used multiple different pieces of brass, etc but the issue persists.
Does anybody have any ideas or have you run into anything similar?
Thanks.