jjm572 Posted October 6, 2012 Share Posted October 6, 2012 Ok guys installed the apex duty kit into my m&p 9 It test fire good with out the back pin in to hold the sear block but once I install that pin the gun does not fire if I remove the pin it works good has any body had this trouble if not any ideas Link to comment Share on other sites More sharing options...
67GTONUT Posted October 6, 2012 Share Posted October 6, 2012 Open up the loop on the trigger bar a couple of thousandths.... should correct the issue. Go to the 10:00min part to show what I am talking about Link to comment Share on other sites More sharing options...
jjm572 Posted October 6, 2012 Author Share Posted October 6, 2012 Thank you very much ill try it out tonight Link to comment Share on other sites More sharing options...
jjm572 Posted October 7, 2012 Author Share Posted October 7, 2012 67 thank you so much it worked I didn't have the gauge to see what the gap was but I moved it a little and boom it works great thanks Link to comment Share on other sites More sharing options...
67GTONUT Posted October 7, 2012 Share Posted October 7, 2012 No problem..... Link to comment Share on other sites More sharing options...
Quack Posted October 7, 2012 Share Posted October 7, 2012 Also push down/hold the slide and make sure that the striker will release as well. Sent from my ADR6425LVW using Tapatalk 2 Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now