[SP-01 Accu Shadow for CO - Direct Mount or Plates?]

Had my Shadow milled and plate from CZC. I like having the ability to go back and forth if I desire. The cut is deep, and that allows my to actually co-witness with the front sight and the little marks on the back of my Vortex Venom that act as a rear sight. Handy. Plus if i decide to go with another optic, I just change out the plate! 

[CZ TS - Nitro Fin and mag release spring]

Just now, Jay870 said:

 

No one make a reduced power mag release spring that I am aware. Just bend the leg on the button side... i.e. if you are a righty that hits the release with your right thumb then bend the left leg in.

 

 

Looks like I'll buy a factory one and play with it. Gotta have a replacement in case the experiment goes sideways!

 

[CZ TS - Nitro Fin and mag release spring]

1 minute ago, Milkcoma said:

i have one on my CZ CTS and CZ TS.   I did have to fit it. took about 5-10 mins with dremel too.   So far i'm liking it alot.  I feel it helps establish your initial grip on the gun alot. 

the back square part has to be rounded for it to pass through the slide.

 

Thanks!!!!

[CZ TS - Nitro Fin and mag release spring]

Two quick questions. First, the Shooting Sport Innovations Nitro Fin for the Tanfo apparently can be fitted for a TS. Anyone done this yet? Thoughts?

 

Second - does anyone make reduced power mag release springs for the TS? I've been unable to locate one.