[Best / Worst Powder Metering in Dillon Powder Measure]

On 9/9/2016 at 11:26 AM, NatureBoy said:

Yes, I did that and had good results with Varget, even in .223

The trick is to slow down and give it time to clear the throat, something I learned here.  It's a good thing too, because Varget works so well with both .223 and .308

2nd this.  Polish the powder bar and slow down a bit and Varget works fine in my 650.

[Aftermarket Billet Aluminum Toolheads]

I've picked up a couple of CNC tool heads for my 650 off of eBay.  Less expensive than Dillon, machined great and in the end worked just as good as a Dillon tool head. I don't think there is any advantage to them, but I wouldn't be afraid of them either.

[Detailed Ghost Holster Instructions?]

Never mind. My newness to this type of holster bit me. Got it figured out.

[Detailed Ghost Holster Instructions?]

Thanks guys. This is helpful. I do have another question though for someone that has one of these holsters. I see two 45 degree flats on the trigger guard pin. It would appear the trigger guard housing slides over these flats when inserting or removing the gun. I assume the trigger guard pin should rotate so it can be in a working position or a locked position as needed. My pin does not rotate at all. When actuating the locking lever, the flats the trigger housing would ride over are turned at an angle to the trigger guard all of the time. The gun will not seat into the holster with the pin not moving. Am I missing something here or what? Some clarification would be helpful. Thanks.