nj0ywatch1np0rn
-
Posts
11 -
Joined
-
Last visited
Content Type
Forums
Profiles
Events
Store
Posts posted by nj0ywatch1np0rn
-
-
The flamed look is a nice touch!
Enough color but not too much.
-
I've ordered a few stuff from different vendors without any issues.
CZ USA received a bunch of thumb rests just FYI. I purchased all 3 types and sent back the 2 I didn't need.
-
Anyone looking to let their extended safety go?
-
Did SSS change the shape of the magwells? I'm looking at the older ones and the new one I received has a flat rear as compared to the older ones being flared at the rear?
-
On 12/14/2016 at 11:01 AM, DialTone301 said:
Which extended mount is recommended for the Razor HD Gen 2? Is 2" enough for the Razor? Is the SPR the proper one?
Do you shoot nose to ch?
-
What's a good adjustable stock that I should look into?
I'm replacing my UBR with something lighter and more adjustability. Been looking at the cole components stock but there's no reviews for it so far.
-
Can vent ribs be changed or do I need to change out the complete barrel assembly?
-
I purchased the Plano hard case that will accept my m2 w/ +8 extension but just barely.
There is about 1/2" of space on both ends.
-
I was wondering what type of case does everyone use to transport their shotguns with?
Most shotguns with an extension will run longer than most typical case will allow!
-
That's what I did. FFT disconnector and nordic follower.
S2 DA pull reduction
in CZ
Posted
Any recommendations for the reduced firing pin spring? Cajun or CZC?