[550b Powder Drop Issues]

I have 8 lb of 7625 and I can not find a cure to get accurate loads. I am trying to acheive 4.6grn but not even close. That sucks! Cleaned and polished hooper with no help. I Know someone out there is the expert on fixing? Do I need to buy a powder dispenser?

[550b Powder Drop Issues]

I am making a load for my glock 34 9m.

[550b Powder Drop Issues]

I just recently changed powder from WSF to IMR 7625. I am having trouble with the powder drop using the 7625.It goes from 4.6-4.0,3.8 back to 4.6. I have cleaned with alchol and still no results. I went back to WSF and the problem went away. I have people that use only 7625 and dont have issues. Any tips is greatly appreciated. I am trying to get 4.6 gr for my glock 34 9m.

[RL 550b Crimp Issues]

I finally found the culprit. I did not resize the case properly. Brian mishap on my part... Thank you all that gave me some input.

James

[RL 550b Crimp Issues]

135 Lead ,124 plated differant manufactuer as well.

[RL 550b Crimp Issues]

I am using mixed brass and Dillon dies. This just started when I converted the set-up from 135 to 124 gr bullets. I'll try reducing the bell and see if this changes anything.

Sarge thanks for the input

James

[RL 550b Crimp Issues]

I recently purchased some 124 9m RN plated (.355) bullets that crimp at .375-.376. I noticed the bullet is spinning in the case. I checked to see if I can push the bullet on the table and it seems ok. When I over crimp .365-.366 it still does the same thing. The bullet it self is .355 so I know that is okay.

I have the OAL set at 1.100 for my glock 34

Am I missing something on my set-up?

Thank for any input

James

[Glock 34 Stock Barrel]

Thank you for the reply. I just ordered some shooter choice.

thanks again

[Glock 34 Stock Barrel]

I just bought a new Gen 4 . Can I use lead bullets in this barrel?

Before I start shooting I was not sure if I can .

Any help is appreciated

[Black Bullets International Load Data Request]

I have some 125gr rn that I need some load data on. I looked in the search engine and there is not much info on it. I have some WSF powder, Fed primers,and mixed brass. I need to make PF with a SW 5906PPC. Any help is appreciated.