[California after 7/1 10 round divisions]

NY is also in the 10 round club. I wanna move.

[Is this holster GTG for production?]

I don't believe so, Appendix D4 #20

"May not be manufactured or cut lower than,

and must cover the slide up to, ½” below the

ejection port (belt slide “Yaqui” type holster

exempt)."

Thank you very much, I owe you a beer, if you drink.

[Is this holster GTG for production?]

Blade Tech Speed Rig, sorry I can't post links.

[Bayou Bullets 200Grn RN]

Not his, but a little with Black Bullet Intl. 200 RN. Pretty sure Donnies is the same bullet, different coating, has a pointier nose and a small shoulder right?

4.5 Clays barely made it out of my PC625 5". Wasn't happy with them taper crimped, seemed to pull out worse than Jacketed or lead due to the coating. And had a bit of trouble roll crimping, they actually wanted to telescope back into the case.

Another problem on the straight Lead Version of that bullet is the shoulder can catch on the reloads. I was hoping the Coated ones would be slick enough to not do that. But I know some do use them and like them. I'm sure if you played with the OAL you could find a good spot.

I've been using the Ranier 200 RN, but it takes a lot more powder!

I just ordered the Ranier 200 RN and was wondering what OAL you use? I load with Titegroup and will start at the lower end of the lead load data per their reccomendations.

[Howdy, from Long Island, NY]

Just checking in to say hi to everyone and looking forward to gaining lots of info. Shoot local matches here on the island and hope to venture out some for next season.