NOT QUITE RIGHT
-
Posts
32 -
Joined
-
Last visited
Content Type
Forums
Profiles
Events
Store
Posts posted by NOT QUITE RIGHT
-
-
Can we send these guns back to SIG for the fix? But is the failure to feed start with a extraction problem?
-
My problems started after several 1000 rounds and I do not have a clue what is wrong. I tried the hotter loads and different COL's without any better results.
-
Please let us know if this extractor fix works. I just started to jam and 1000's of rounds without a problem. And I have looked at everything.
-
Get a MagLula
-
Where can I buy parts for my 41 other than S & W ?
-
Powder Valley or Mid South
-
They are no good. Drop and trickle
-
Check snipershide forum but I would not use the stuff. By the time you add the water lemi shine and the media you only have less than 2lbs left for brass in a 15lb tumbler and you can't go to bed while it is cleaning
-
Get the Redding GRX
-
Throw a little Redding Imperial on every 10th case or so
-
Berrys
-
-
Use a good taper crimp die for the 38 and a roll crimp for the 357mag
-
Does anyone have a good 148 DEWC Load that is very clean for a revolver?
-
I use clays in a hornady and it meters excellent
-
Redding Taper Crimp Dies and seat and crimp seperately
-
I use Unique with good results but I also like IMR 7625
-
IMR 7625 works good for all bullet weights
-
4.3 Clays
-
You should n ot have to change a thing for a change of .001 in a lead bullet diameter
-
I would use the Redding GRX first
-
NO size die has nothing to do with seat or crimp
-
No it does not.
-
10rd mags are hard to seat when full
in S&W (M&P, etc)
Posted
With that being said maybe he should carry a small hammer with a rubber end so as not to damage the mag.
I told everyone up front that I was NOT QUITE RIGHT. Sorry I should have read better.