[Stock 2 trigger not activating hammer]

On 8/4/2022 at 11:31 PM, Polymer said:

If it was working fine, you need to check trigger bar where it contacts bolo ear to see if it's worn/rounded off.

 
will do.  I never knew the trigger bar could wear out.  Which bar is the best?

[Stock 2 trigger not activating hammer]

The crazy thing was that it was working fine for 5 years since I have had the gun.  Now I need to fit it?  
 

I will try it but it’s odd to me why it started to happen 

[Stock 2 trigger not activating hammer]

Thanks guys, I put the stock disco back in and pull is back to normal . The bolo I have looks to be normal.  Any ideas as to why it’s not allowing me to pull the DA?

 

all my findings are in the link below

 

https://www.dropbox.com/sh/ms24frzijewqvbh/AAC35xNzKtfIlyWGCtK0jDKia?dl=0

[Stock 2 trigger not activating hammer]

thanks for the tips so far!  Everything looks normal to me.  It has to be the plunger spring not pushing the trigger bar up enough right?  
 

I would think this only started to happen if a spring became too weak.  I would not think this is due to metal pieces being too worn.

 

here is a video of the internal

https://www.dropbox.com/s/i4uawpmy35mgu2t/internal.mov?dl=0

[Stock 2 trigger not activating hammer]

Hey Gents,

 

First time poster, long time reader!  I know you guys have unlimited knowledge so I figure I ask you guys before bringing to a gunsmith.  
 

my stock 2 has been flawless through 5k rounds.  It recently just started to run into this issue where I pull the trigger in DA and the hammer will not go back.  It looks like something is slipping?!  SA still looks normal.  I just changed out the trigger spring and to see if it helps but it did not.  Any guidance on why this is happening and how I can fix it is greatly appreciated! 
 

below is the video of what I’m talking about:

https://www.dropbox.com/sh/ms24frzijewqvbh/AAC35xNzKtfIlyWGCtK0jDKia?dl=0