Hello, I currently use a Lee Classic Cast Turret to reload. I clean, deprime and size then clean the pistol brass. To clean I keep it simple and just soak them then dry them. So I begin my reloading by seating the primer with a fwd stroke. Then I load powder with a Lee auto drum in station 1, Hornady bullet feeder in 2, seat in 3 and Lee FCD in 4. This is on a turret press that has the auto index rod enabled. I have been pondering the same procedure and set up on a Dillon 550. I like this model as it is essentially a turret press with a shell plate vs a single shell holder. I do not have one to set this FrankinDillon operation up on. I am also unclear as to what might happen if you mix Red & Blue to make bullets. Will it end up purple ? So, if you have a desire to try out a purple press shoot a video of it and give us a full report. I am guessing this would increase production by 2-3x over my LCT, perhaps 1.5x of a 550 and still be a simple machine. Thanks https://www.youtube.com/watch?v=FaPoU1mCRW0
http://ultimatereloader.com/2016/05/20/lee-auto-disk-powder-measure-from-unboxing-to-loading-pistol/