redwoods Posted April 22, 2009 Share Posted April 22, 2009 STI Tactical 40sw bull barrel - ramped 126mm mags I noticed that the lower right corner of my feed ramp is getting dented and it is becasue of the mags. The mags are dented also. I am not sure if it happens when the slide is closed or locked back. Can I dremel the mags so they don't hit the feed ramp? Is that the best way to go? Thanks, Randy Link to comment Share on other sites More sharing options...
XRe Posted April 22, 2009 Share Posted April 22, 2009 Can I dremel the mags so they don't hit the feed ramp? Is that the best way to go? Yes x2... at least, that's what I've done to all of mine... Link to comment Share on other sites More sharing options...
Dan Sierpina Posted April 23, 2009 Share Posted April 23, 2009 I use the sanding drum to relieve the mags. No more beating up the ramp or mags. Link to comment Share on other sites More sharing options...
Pat Miles Posted April 24, 2009 Share Posted April 24, 2009 I printed the picture from the Enos forum but couldn't find it with a search though. Google this: http://www.brianenos.com/forums/index.php?...st&id=14060 This is a tip that Dan Bedell posted to cure the problem you describe. Sorry about the long address. As you can tell I am digitally challenged. I know where to turn my computer on and off at. The electrical plug at the wall right? CYa, Pat Link to comment Share on other sites More sharing options...
HI5-O Posted April 25, 2009 Share Posted April 25, 2009 Can I dremel the mags so they don't hit the feed ramp? Is that the best way to go? Yes x2... at least, that's what I've done to all of mine... Me too didn't take much Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now