Swapping 550 toolheads to another 550

[High Lord Gomer]

I'm probably going to be loaning a few toolheads to a friend to use on his 550 and I wondering if the dimensions of the press might be different enough to require readjustment of the dies and/or trimmer.

Has anybody that swapped toolheads to another 550 found enough difference to warrant readjustment?

[Bigpops]

I'm probably going to be loaning a few toolheads to a friend to use on his 550 and I wondering if the dimensions of the press might be different enough to require readjustment of the dies and/or trimmer.

Has anybody that swapped toolheads to another 550 found enough difference to warrant readjustment?

I have three toolheads for my 550. Once set, they are perfect...but I still check everything to be sure. If I were to use one set for another 550 I would check it out for sure.

[D.Hayden]

I have 2 550's and swap the heads all the time.

I'll confirm bullet seating for OAL, but that's it. Never had an issue.

[Bigpops]

I have 2 550's and swap the heads all the time.

I'll confirm bullet seating for OAL, but that's it. Never had an issue.

nevermind...re-read

Edited April 8, 2009 by Bigpops

[astephenson]

It'll be close, but I'd still check to make sure.

[High Lord Gomer]

Cool...thanks everyone!