Jump to content
Brian Enos's Forums... Maku mozo!

Install G35 Slide And Barrel On G34


spankymac

Recommended Posts

I have a G34 that that my son has taken over and is now wanting to shoot major with on a low budget. I have friend that has offered me a new G35 barrel, slide and mags. Will this swap work? If so what else is needed?

Thanks for your time to advise

Link to comment
Share on other sites

I'm certainly not an armorer but if it's a 3rd gen frame (3 pin) it will work.

I shoot a stock G17 top end on a stock G35 bottom end for Production (don't tell anyone ;) ) and in Open I shoot a comped G35 top end on a tricked out G17 bottom end. (It's a long story but it works.) The 9mm ejector will work with the .40 but it is easy and inexpensive to change.

Hell I even use .40 mags loaded with 9mm in the G17 (or would that be the 35 (with the 17 top end?) anyway) it will feed but use the proper mags for the caliber.

Nick

Link to comment
Share on other sites

The 34 and 35 locking blocks are listed as two different parts in the Glock armorer book. However, they "look" identical. I'd give them a call and find out for sure. They are $10 or $15 I think, my book is at work.

The trigger control mech with ejector is $3. Might as well swap that over. Trigger with trigger bar is the same.

S

Link to comment
Share on other sites

  • 1 month later...

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...