IPSCLUVERRR Posted September 12, 2022 Share Posted September 12, 2022 I had a 100% functioning automated press at one point. I left the press alone for about 8 months as I was busy with life. When I come back to the press I get nothing but torque sense readings. It will not let me run the press. I have taken the press fully apart, cleaned, lubed everything. No matter what I do I can not get it to function. Lubed brass, etc. Any ideas? Quote Link to comment Share on other sites More sharing options...
HesedTech Posted September 12, 2022 Share Posted September 12, 2022 (edited) 17 minutes ago, IPSCLUVERRR said: Any ideas? Call them, not email, directly. 1-888-4-mark77 I had a drive (sold it for an Ammobot) before they were bought out and the support really was good back then. BTW, did you do a firmware update? That might help reset the system. Edited September 12, 2022 by HesedTech Quote Link to comment Share on other sites More sharing options...
Sincerd Posted September 20, 2022 Share Posted September 20, 2022 When is it activated? Up stroke? Down stroke? Pictures or video wouod help get you an answer. Could need a tool head realignment but most likely a die/brass issue if not smashing primers. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.