Jump to content

Hyperfire 24 C problem


Recommended Posts

I just installed a Hyperfire C in my PSA 9mm lower,

I have a trigger pull that is over 7 lbs. Trigger checks out as far as reset

and all safety checks.

I cannot seem to find a contact for Hyperfire.

Link to comment
14 minutes ago, dmshozer1 said:

I just installed a Hyperfire C in my PSA 9mm lower,

I have a trigger pull that is over 7 lbs. Trigger checks out as far as reset

and all safety checks.

I cannot seem to find a contact for Hyperfire.

I found their contact information.

Nothing yet.

Link to comment

Have you checked the same and the cam springs to make sure all of that is installed correctly? 

 

Also, check the hammer spring and compare it to the old hammer spring to make sure it's pre-compressed enough. 

 

Just my two cents...

Link to comment

Found the problem,

Somehow one hammer spring got under the trigger spring?

I should have known I had a problem.

I had a hell of a time lining up the hammer to put the pin in.

Duh. I have put in lots of triggers.

Thanks for the help.

Link to comment
Just now, dmshozer1 said:

Found the problem,

Somehow one hammer spring got under the trigger spring?

I should have known I had a problem.

I had a hell of a time lining up the hammer to put the pin in.

Duh. I have put in lots of triggers.

Thanks for the help.

Nice 2-1/4 lb trigger,

I usualy run Gold triggers but the reset on them is almost nothing so

I thought I would try the Hyperfife.

I will shoot a few matches to see if the reset matters or not.

Link to comment
  • 3 months later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...