nunya Posted August 31, 2021 Share Posted August 31, 2021 The device functions fine but the pull weight measures out to 3.5lbs. This is a reduction from the 4.5lbs or so before I moved from OEM to a 4lb striker spring and OEM to a minus connector. I've polished here and there and lubricated where needed. How can I get the pull weight lower at this point? I can't identify any burrs or dragging points causing this... Link to comment Share on other sites More sharing options...
Hvansky Posted October 15, 2021 Share Posted October 15, 2021 Good to know, I just got my timney delivered and and using factory springs. Excited to see the difference Link to comment Share on other sites More sharing options...
sandflea316 Posted October 15, 2021 Share Posted October 15, 2021 Try a reduce power plunger spring Link to comment Share on other sites More sharing options...
ShooterMcgeez Posted December 30, 2021 Share Posted December 30, 2021 I'm running a 5lb striker spring, reduced power safety spring, minus connector and I am getting a sub 2lb pull - g19.5 with about 6000 rounds through it prior to adding a timney. Make sure you grease where there is friction (connector etc). Link to comment Share on other sites More sharing options...
bigtimelarry Posted December 30, 2021 Share Posted December 30, 2021 11 minutes ago, ShooterMcgeez said: I'm running a 5lb striker spring, reduced power safety spring, minus connector and I am getting a sub 2lb pull - g19.5 with about 6000 rounds through it prior to adding a timney. Make sure you grease where there is friction (connector etc). If you run a Stock 5.5 lb spring, will it make the Trigger pull 1/2 lb harder ? If it does than ok, but if it doesn't you get another 1/2 lb hitting the primer.. Link to comment Share on other sites More sharing options...
bubba72 Posted December 30, 2021 Share Posted December 30, 2021 On 8/30/2021 at 11:25 PM, nunya said: The device functions fine but the pull weight measures out to 3.5lbs. This is a reduction from the 4.5lbs or so before I moved from OEM to a 4lb striker spring and OEM to a minus connector. I've polished here and there and lubricated where needed. How can I get the pull weight lower at this point? I can't identify any burrs or dragging points causing this... If you want to get the trigger pull lighter you can take the Timney housing and take the two pins out that hold the sear in position and take the spring out of the housing and clip a couple turns off. If you take it apart check for burrs inside of the housing where the holes have been drilled through the housing. I had a housing where the sear would not move at all. Took it apart and there were some small burrs where the holes had been drilled through the housing. I used some fine grit sandpaper to clean up the burrs and put it back together and it worked fine after removing the burrs. I also removed some metal from the end of the trigger bar where it could rub against the frame if the trigger connector pushed it out towards the frame. My trigger pull weight is currently 2.5 lbs average with a Wheeler electronic gauge. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now