Single action break

[DougCarden]

First off I wanna thank everybody for putting the knowledge on this sub forum. I bought an SP01 and went through it and did all the mods and it is quite simply amazing. I have the 11 pound hammer spring in the gun, trued up the hammer hooks on the hammer.  I am just over 6lb DA and around 3 1/2 SA.  I still have a small hitch at the break of SA when I am shooting groups with it.  My question is if I should work on the sear and what is suggested.    Thanks in advance

[jripper]

Couple of questions:  Did you change hammer/sear?  Is this a SP01 or a SP01 Shadow (is there a firing pin block)?

[DougCarden]

Hammer and sear not changed, and just SPO1.  Not the Shadow

[adovlad]

i did same thing with my sp 01

after installed mcarbo and shoot 1000k, trigger was 5.3/4 and 3.5 respectively.

it was great, but it wasn't enough for rookie like me , who graduated to next level.... i sent the gun off to cz ghost for upgrades.

gun arrive tomorrow with cz made and fitted 4.8 barrel, cz accu bushing.

and i converted to cz made single action trigger with all the work.

I found myself mire of a bulls eye shooter, so i believe upgrades will satisfy my needs at range. 

[ima45dv8]

15 minutes ago, adovlad said:

{snip}....and shoot 1000k

A million rounds...

For real?!

Typo maybe?

[jripper]

I personally would put in a Cajun Hammer/sear kit, along with the short reset parts.  It should make a significant difference in the trigger pull.

[eerw]

keep the sear, its good.

install one of the comp hammers, better hook geometry.

 

Edited July 14, 2021 by eerw

[DougCarden]

On 7/14/2021 at 4:48 PM, eerw said:

keep the sear, its good.

install one of the comp hammers, better hook geometry.

 

Thanks Stuart!