venatic Posted May 22, 2021 Share Posted May 22, 2021 I have ran a bunch of 223 brass thru a Lee APP and decapped then SS cleaned. Does this setup on an Apex 10 look like a viable way to one pass load from there. First spray One Shot then dump in case feeder .....so the order would look like this: 1. Case feed to plate 2. Trimmer die with Dillon Trimmer 3. Hold down die/swager 4. FL die with decapping removed/ primer station 5. Lyman M die expander 6. Powder thrower 7. Magnetic powder check 8. Mr Bullet dropper 9. Seater die 10 Lee FCD Link to comment Share on other sites More sharing options...
RGA Posted May 25, 2021 Share Posted May 25, 2021 If you place the Dillon trimmer in station 2 you will not be able to use station 3 (swaging) anymore. The bulk of the Dillon trimmer sits too low. Link to comment Share on other sites More sharing options...
venatic Posted May 25, 2021 Author Share Posted May 25, 2021 Thanks that’s what I needed to know. Link to comment Share on other sites More sharing options...
m700 Posted September 20, 2021 Share Posted September 20, 2021 Could you have a low profile hold down made? with a nut on the bottom? Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now