Snowman50 Posted March 31, 2021 Share Posted March 31, 2021 I decided to clean-out extractor after over 2k rounds on my Shadow 2 OR. While tapping pin back in, it rolled off table and into the dirt it went, Lost. I had a spare (BenStoegerProShop). My thought was, spare is too long, but wasn't sure, as I installed pin; yes, too long as it would not seat flush with bottom of slide. I ordered 4 more extractor pins from Ben, & sure enough, these looked too long! Well, I figured I'll get out my back-up unfired Shadow2, and pull the pin. Pin measured .334; spare pin: .518, BIG DIFFERENCE! What are the odds that the part no. is correct, but the wrong pins are in the packaging? I'd bet on that I shouldn't need to cut the pin to the proper length of .334 inches. For now, I used the pin from my back-up Shadow2, but what's the solution? do parts get miss-packaged? Has this happened to anyone with Shadow 2 OR? I will call Ben's shop today and hear what they have to say.. Link to comment Share on other sites More sharing options...
Foxj66 Posted March 31, 2021 Share Posted March 31, 2021 The OR guns have a shorter extractor pin it is CZ part 0330025002 Did you order a standard extractor pin? Link to comment Share on other sites More sharing options...
Snowman50 Posted March 31, 2021 Author Share Posted March 31, 2021 56 minutes ago, Foxj66 said: The OR guns have a shorter extractor pin it is CZ part 0330025002 Did you order a standard extractor pin? No. I looked for OR ,but I on had seen part no. 0330025001. I checked CGW: not even listed 1 hour ago, Foxj66 said: Link to comment Share on other sites More sharing options...
Snowman50 Posted March 31, 2021 Author Share Posted March 31, 2021 AND CZusa is out of stock Link to comment Share on other sites More sharing options...
Foxj66 Posted March 31, 2021 Share Posted March 31, 2021 I know BSPS has some on order. Link to comment Share on other sites More sharing options...
Snowman50 Posted March 31, 2021 Author Share Posted March 31, 2021 Thanks! PM just sent to you Link to comment Share on other sites More sharing options...
MikeBurgess Posted March 31, 2021 Share Posted March 31, 2021 just Dremel off the pin to the desired length. for my Tanfoglios I bought a couple packs of roll pins from McMaster in the longer lengths and just cut them down as needed, I think they are like $5 for 50 Link to comment Share on other sites More sharing options...
Nils Posted July 21, 2021 Share Posted July 21, 2021 On the OR - did you remove the pin the same way as on other shadow2, from the top down? Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now