jabate01 Posted August 3, 2020 Share Posted August 3, 2020 I finished my first 2011 build. To my surprise it actually shoots and it is more accurate than I am. I am having some reliability issues, though. First issue is a sticking of the slide. When to the gun starts to get hot after a few rounds, the slide begins to get stuck in battery and it takes a lot of force to rack the slide and eject the spent casing. When the gun cools down again, seems to work fine for a bit. Any ideas on why this is happening? Link to comment Share on other sites More sharing options...
stardust tommy Posted August 3, 2020 Share Posted August 3, 2020 is the fit of the barrelhood verry tight? I had an open gun with the same problem... only with VV 3N37 (no probs with 3N38 or N350) took .001-.002" from the lengt of the barrelhood and the problem was solved. Link to comment Share on other sites More sharing options...
mcattack Posted August 3, 2020 Share Posted August 3, 2020 Something is to tight, Hood, bushing or slide, free it up a little and should still be OK. Link to comment Share on other sites More sharing options...
jabate01 Posted August 4, 2020 Author Share Posted August 4, 2020 Stardust Tommy, I have no idea what you just said. mcattack, hood is not tight, its a bull barrel and the slide seems to move fine. Could it be the lugs? As the barrel heats up, could it swell and become to tight in the slide? Link to comment Share on other sites More sharing options...
427Cobra Posted August 4, 2020 Share Posted August 4, 2020 degrease everything, then take a Marks A lot, and mark all suspected areas, cycle the slide a dozen time and examine the marked areas for worn off marker Link to comment Share on other sites More sharing options...
NoSteel Posted August 4, 2020 Share Posted August 4, 2020 Some pictures of the frame , slide & barrel apart would be more helpful.... Link to comment Share on other sites More sharing options...
jabate01 Posted August 5, 2020 Author Share Posted August 5, 2020 What specific parts of the barrel, slide, frame should I photograph? Link to comment Share on other sites More sharing options...
NoSteel Posted August 5, 2020 Share Posted August 5, 2020 Did you do the fitting / assembly of all parts or someone else? I ask only because fitting correctly would require knowing where the slide / barrel and frame critical dimension points are. As others suggested, sounds like allot of work with a sharpie & stones may be in your future... Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now