JesseM Posted July 5, 2020 Share Posted July 5, 2020 With 9mm being harder to find than hens teeth I'm going to be using my Mk4 22/45 to practice some drills so I'd like to get a holster for it, ideally something that is kydex and uses a paddle or a Tek-Lok attachment so I can swap holsters easily during a range session. The only holster I'm finding anywhere is a tactical solutions holster but it looks like they only have their belt attachment which isn't a quick on and off. Link to comment Share on other sites More sharing options...
SteelCityShooter Posted July 6, 2020 Share Posted July 6, 2020 The Tactical Solutions' holster (aka Black Dog and also sold by TandemKross) has it's belt attachment plate held on by four screws and it is removable. I'm sure you could attach a Tek-Lok in its place. Link to comment Share on other sites More sharing options...
JesseM Posted July 7, 2020 Author Share Posted July 7, 2020 Well then I guess I'll give that one a go. Link to comment Share on other sites More sharing options...
JesseM Posted July 9, 2020 Author Share Posted July 9, 2020 Well it doesn't fit the gun with a red dot on it so that's a no go. Link to comment Share on other sites More sharing options...
SteelCityShooter Posted July 9, 2020 Share Posted July 9, 2020 1 hour ago, JesseM said: Well it doesn't fit the gun with a red dot on it so that's a no go. It certainly fits my MkIV with a Vortex Venom on an Alchin mount. It will clear any red dot and mount that doesn't overlap the receiver/barrel junction. If you use Ruger's or an aftermarket Pic rail mounted so it sticks forward over the receiver/barrel junction, the rail will interfere with the holster. The solution is to either mount it "backwards" by removing the rear sight or shorten it. Link to comment Share on other sites More sharing options...
JesseM Posted July 9, 2020 Author Share Posted July 9, 2020 (edited) It does not work with the Maddmacs RMR mount; I think it sits too low. It looks like it should but it's a no go. Edited July 9, 2020 by JesseM Link to comment Share on other sites More sharing options...
Farmer Posted July 19, 2020 Share Posted July 19, 2020 Die grinder & carbide bit. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now