Babayaga Posted July 3, 2020 Share Posted July 3, 2020 Anyone ever add more epoxy/silicone carbide to an already finished grip that’s had a SC treatment. I switched epoxies and the last grip I did came out thinner than I would like. I was wondering if I can add epoxy and SC or do I need to remove everything and start over. ‘thanks, John Link to comment Share on other sites More sharing options...
SGT_Schultz Posted July 4, 2020 Share Posted July 4, 2020 Coat it and sprinkle it again Link to comment Share on other sites More sharing options...
Babayaga Posted July 7, 2020 Author Share Posted July 7, 2020 Thanks SGT Link to comment Share on other sites More sharing options...
SGT_Schultz Posted July 7, 2020 Share Posted July 7, 2020 I've had most success by sprinkling the grit on the epoxy, patting it down, shaking off the excess, and repeating that process at least once more until no more grit sticks. In the past I just sprinkled it on without touching the grit. Once the epoxy dried, too much grit came off and the effectiveness was reduced over time. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now