rancher5 Posted August 23, 2019 Share Posted August 23, 2019 Have a Tanfo Team Gold,the minor load barrel has one cut comp, what problems would I encounter if I cut that comp port off ? Sent from my SM-G955U using Tapatalk Link to comment Share on other sites More sharing options...
IPSCLUVERRR Posted September 3, 2019 Share Posted September 3, 2019 I haven’t cut a tangfo comp but i did cut a 4 port egw comp down to 2 ports for my steel gun. It’s holding up fine (~12000 rds of 100pf). The only downside is that the front of the comp is angled Link to comment Share on other sites More sharing options...
rancher5 Posted September 3, 2019 Author Share Posted September 3, 2019 Good to know I imagine you don't have to worry about the rifling , besides not leaving any bures or rough spots, How did you cut it? Link to comment Share on other sites More sharing options...
IPSCLUVERRR Posted September 6, 2019 Share Posted September 6, 2019 I cut it with a hacksaw then faced it in a mill to make a clean cut. I then used a 9mm comp alignment reamer to double check that I didnt have any burrs in the path of the barrel. Link to comment Share on other sites More sharing options...
rancher5 Posted September 6, 2019 Author Share Posted September 6, 2019 13 hours ago, IPSCLUVERRR said: I cut it with a hacksaw then faced it in a mill to make a clean cut. I then used a 9mm comp alignment reamer to double check that I didnt have any burrs in the path of the barrel. Thank You, Vert concise and thorough, Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now