Jump to content
Brian Enos's Forums... Maku mozo!
urmaker45

What baseplates for 2011 limited ?

Recommended Posts

Which baseplates you guys run on a sti edge with stock mags ? I was thinking tti 140 mm 40 cal . I was told mbx baseplates would be loose on stock gen I mag.  I was going to do gram follower with tti baseplates unless you guys think there is better ?

Share this post


Link to post
Share on other sites

when brazos made up 4 tuned mags to go along with the hp edge i bought from them, they used dawson snl baseplates.  i think grams springs/followers but not 100% sure.  gun has run 100.0000% with .40 major and just a few hiccups over the years when i've run it with .40 minor at some steel matches.

 

just fyi i bought some dawson snl basepads for some open gun mags and they were too long to fit the gauge.  not sure what if anything i could do to make them fit, haven't messed with them yet, back burner.  but actually i just bought my own gauge so will see what can be done.

Share this post


Link to post
Share on other sites

I have had Dawson, Grams, TTI and some unknown base pads on STI and SVI mags in 40sw.  Of all of them I like the TTI the best.  Honestly, I couldn't tell any difference between Grams followers and springs in STI mags.  They both worked.  The was a decided difference in the SVI tubes.  They definitely preferred TTI guts.  I always run MBX mags, but I do use the others.  They all have TTI guts and pads now.

Share this post


Link to post
Share on other sites

TTI pads and Grams guns give me 21 in all my STI mags

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...