bossk95 Posted June 1 Hey everyone I bought a casefeeder for my 650 a couple months ago, I have about 5k cycles through my press between decapping brass and loading live ammo and every so often it drops a case in upside-down. Is there any way to prevent this from happening? Quote Share this post Link to post Share on other sites
ClayBuster Posted June 1 Mine used to do that until I made a brace and bolted it to the wall, i get maybe one every few thousand now. How solid is your mount? Quote Share this post Link to post Share on other sites
CSEMARTIN Posted June 1 1 hour ago, ClayBuster said: Mine used to do that until I made a brace and bolted it to the wall, i get maybe one every few thousand now. How solid is your mount? ClayBuster, Can you post a photo of the brace you made? Quote Share this post Link to post Share on other sites
ClayBuster Posted June 1 17 minutes ago, CSEMARTIN said: ClayBuster, Can you post a photo of the brace you made? Best I can do for now. Quote Share this post Link to post Share on other sites
CSEMARTIN Posted June 1 Thank you. That is very helpful. Quote Share this post Link to post Share on other sites
bossk95 Posted June 2 (edited) 4 hours ago, CSEMARTIN said: ClayBuster, Can you post a photo of the brace you made? It's not very solid right now, it's butted up against a cabinet right now that I haven't had a chance to tear out so it kind of floats a little, I'll have to rip that out soon and see if that helps thank you! Edited June 2 by bossk95 Quote Share this post Link to post Share on other sites
