Modifying Mag Catch - Production

[B21]

I've recently started using the tanfo custom mag catch, as I just can't reliably release the mag without it, (unless I run thin grips which I also dislike).  However it's too big and lately I've been inadvertently dropping a mag, particularly after a reload if my grip is just a little off.  I know the aftermarket mag catches are good to go under the new production rules, but is it okay to modify an aftermarket catch?  I'm going to grind away some of the excess material if so.   I wish someone would make an adjustable paddle like on the Shadow 2.  

[JayTac556]

I've recently started using the tanfo custom mag catch, as I just can't reliably release the mag without it, (unless I run thin grips which I also dislike).  However it's too big and lately I've been inadvertently dropping a mag, particularly after a reload if my grip is just a little off.  I know the aftermarket mag catches are good to go under the new production rules, but is it okay to modify an aftermarket catch?  I'm going to grind away some of the excess material if so.   I wish someone would make an adjustable paddle like on the Shadow 2.  

Yes, you sure can modify it how ever you see fit. In the new production rules you can change any mag release to an aftermarket or factory or even make your own.

Grind away..... you'll be good to go.

Sent from my SM-G960U using Tapatalk

[B21]

13 hours ago, JayTac556 said:

Yes, you sure can modify it how ever you see fit. In the new production rules you can change any mag release to an aftermarket or factory or even make your own.

Grind away..... you'll be good to go.

Sent from my SM-G960U using Tapatalk
 

Thanks bud,  I shall grind away!