Jump to content
Brian Enos's Forums... Maku mozo!
Sign in to follow this  
phil plesetz

Tanfoglio Gold Team

Recommended Posts

I guess i may have answered my own question. Installed a Henning short reach trigger for the wife and adjusted out some of the over-travel, and even though the hammer falls, I may have went to far. The gun will not fire.

 

anyone have experience with this?

Share this post


Link to post
Share on other sites

Sound like it’s falling to half cocked position, and your pre travel over travel screws aren’t adjusted correctly the short reach can hit frame not letting sear release enough to drop hammer fully 

Share this post


Link to post
Share on other sites

No mag disconnect.  As you are now realizing, getting a little too aggressive with taking out either over or pre travel on the Tanfos will give you problems.  They don't require a lot of either, but they definitely require a little.  

Share this post


Link to post
Share on other sites

Is your firing pin safety still in the gun?

If so is your lifter moving out of the way to allow the fp to move forward.

Share this post


Link to post
Share on other sites

i  put back some of the over-travel I removed and all is well. Didn't realize if the sear hammer disengagement the gun wouldn't fire.

Share this post


Link to post
Share on other sites
On 3/28/2019 at 11:02 AM, jcc7x7 said:

Is your firing pin safety still in the gun?

If so is your lifter moving out of the way to allow the fp to move forward.

That ^

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...