Echd Posted March 25, 2019 Share Posted March 25, 2019 I've had a bullet tray for my 1050 laying around for months and finally was going to mount it. I realized as I was trying that I am missing the bolt that attaches the bracket to the case feeder support. Would anyone mind checking the thread pitch and length of the bolt? If it is common I will just pick one up at lowes or ace tomorrow. Link to comment Share on other sites More sharing options...
Hawk21 Posted March 25, 2019 Share Posted March 25, 2019 I have a new one sitting at my office will send info over in the AM if no one is able to help you out sooner Link to comment Share on other sites More sharing options...
Echd Posted March 25, 2019 Author Share Posted March 25, 2019 Thanks! Link to comment Share on other sites More sharing options...
Hawk21 Posted March 25, 2019 Share Posted March 25, 2019 Pacakage contained (4) of these so I assume it uses the existing bolt thru the case feeder support, if not then I’m of need also Link to comment Share on other sites More sharing options...
AHI Posted March 25, 2019 Share Posted March 25, 2019 (edited) the two bolts that hold it to the machine are bolts you remove to mount it the original bullet ben bracket Edited March 25, 2019 by AHI Link to comment Share on other sites More sharing options...
Hawk21 Posted March 26, 2019 Share Posted March 26, 2019 8 hours ago, AHI said: the two bolts that hold it to the machine are bolts you remove to mount it the original bullet ben bracket Yep that’s what I figured thanks for confirmation Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now