AF2010 Posted March 2, 2019 Share Posted March 2, 2019 (edited) I just installed the EGW koenig trigger kit and SVI trigger on my Trojan 1911... Everything appears to be functioning fine except I'm now getting 2 clicks on reset. First click happens as soon as I begin to rack the slide and I can feel it in the trigger. And second click is the normal reset as I let the trigger out. Any ideas what's going on? I'm thinking its the disconnect? Edited March 2, 2019 by AF2010 Link to comment Share on other sites More sharing options...
jwhittin Posted March 2, 2019 Share Posted March 2, 2019 Remove your grip safety and thumb safety so you can visually see what's happening during the reset. I had a similar problem and it turned out the trigger bow was loose vertically and shifting positions during reset. Link to comment Share on other sites More sharing options...
pskys2 Posted March 2, 2019 Share Posted March 2, 2019 Does sound like the disconnect. Does it do it with and without the mag in place? Try either the original trigger with the new kit or the original hammer, sear, disconnect and the new trigger. Should narrow it down. Then start replacing parts piece by piece. Link to comment Share on other sites More sharing options...
yigal Posted March 2, 2019 Share Posted March 2, 2019 (edited) 38 minutes ago, pskys2 said: Does sound like the disconnect. Does it do it with and without the mag in place? Try either the original trigger with the new kit or the original hammer, sear, disconnect and the new trigger. Should narrow it down. Then start replacing parts piece by piece. for all combinations it could take few years first try to adjust correct over travel of the trigger in both directions. Edited March 2, 2019 by yigal Link to comment Share on other sites More sharing options...
CHA-LEE Posted March 3, 2019 Share Posted March 3, 2019 All of those parts are not “Drop In”. You are rolling the dice on simply throwing them in and hoping that it will work properly. Link to comment Share on other sites More sharing options...
yigal Posted March 3, 2019 Share Posted March 3, 2019 (edited) 6 hours ago, CHA-LEE said: All of those parts are not “Drop In”. You are rolling the dice on simply throwing them in and hoping that it will work properly. and a little prayer would not hurt before installation . Edited March 3, 2019 by yigal Link to comment Share on other sites More sharing options...
pskys2 Posted March 3, 2019 Share Posted March 3, 2019 Guys I'm not suggesting he throw parts together and run it. Just a method of narrowing down the Click, while dry firing. And FWIW except for sear to safety engagement or disconnector operation most of those parts may very well work, to one degree or another. Except for the hammer falling to half cock no damage will be done in dry firing. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now