DannyBoyy Posted February 9, 2019 Share Posted February 9, 2019 Apologies but I have a novice question. I took a rise armament 240 trigger out of my M&P 15-22 (was giving light strikes anyways) and went to put it in the my CQ10 lower, with the pins that came with the RA240. But when I went to tighten them down the pins are a bit too long. Sure enough I got some michs out and the wall thickness is of the the qc10 is 1-1.5 mm thinner, which i get we are talking metal vs plastic. Question is if I get some KNS pins or something like that, should I be just fine? The diameter of the pins are fine but the length is just a bit off (long). What is known to work with the qc10 lower Quote Link to comment
Startingover Posted February 9, 2019 Share Posted February 9, 2019 Your 15-22 uses longer "polymer lower" length pins. Any standard pin should work. Quote Link to comment
Startingover Posted February 9, 2019 Share Posted February 9, 2019 I just use the inexpensive CMC pins on everything. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.