Jamese35 Posted September 16, 2018 Share Posted September 16, 2018 Hey every one I'm looking for a place to buy a spare 929 hammer as I'm looking at playing with one to lighten it up and want a backup in case I mess it all up. Also the ones I found are all MIM and I'm not sure if I would be ok with that or if the cutting and polishing would mess with the structural strength and durability. And on a side note they also say .500 or. 400.... what does this mean and what and where should I be looking? Thank you jimmy Link to comment Share on other sites More sharing options...
Jamese35 Posted September 17, 2018 Author Share Posted September 17, 2018 Any body have anything? Link to comment Share on other sites More sharing options...
vtecpaoche Posted September 17, 2018 Share Posted September 17, 2018 I went the route of just replacing the hammer with an Apex hammer. According to Apex, all non-performance center parts are MIM and performance center revolvers after Jan 2012 are also MIM. I know a local guy who does revolver work. He has bobbed the MIM hammers before. The .400 or .500 should refer to the hammer spur width. If you are bobbing it, it shouldn't matter. Link to comment Share on other sites More sharing options...
Jamese35 Posted September 17, 2018 Author Share Posted September 17, 2018 Thank you for the info it helps alot. Link to comment Share on other sites More sharing options...
Dr. Phil Posted September 17, 2018 Share Posted September 17, 2018 You can go on sites such as Numrich Arms (aka Gun Parts Corp) and buy stock hammers for 15 or 16 bucks. Bob to your little heart's content with no worries. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now