bigdawgbeav Posted May 7, 2018 Share Posted May 7, 2018 This is going to seem like an odd question, but would anyone be able to measure the width of their Q5 trigger guard? I am looking to do a comparison to another polymer pistol and since I don't have an Q5, I can't take a set of calipers to it. Link to comment Share on other sites More sharing options...
bigdawgbeav Posted May 8, 2018 Author Share Posted May 8, 2018 No one huh? Link to comment Share on other sites More sharing options...
random_guy7531 Posted May 10, 2018 Share Posted May 10, 2018 I don't have a Q5, but I do have a standard PPQ. I don't think the frames are different between the two (or at least they certainly did not seem to be from when I handled the Q5). On my PPQ, the trigger guard is 15.5mm +/- 0.1 wide except for back near the grip and undercut, where it widens out. At the farthest back where I would still consider it part of the trigger guard (as opposed to the mag release scallop), it appears to about 26mm. Link to comment Share on other sites More sharing options...
MemphisMechanic Posted May 10, 2018 Share Posted May 10, 2018 The standard PPQ frame is identical to the Q5’s frame. Link to comment Share on other sites More sharing options...
bigdawgbeav Posted May 10, 2018 Author Share Posted May 10, 2018 Thanks for the replies. I have the Canik TP9 SFx and right now no one is making a race holster for it. Was trying to find something close that I might be able to make work. Turns out the Canik guard is .58" The Walther insert might actually work... if it's a little loose could probably shim it a little. Thanks again. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now