bigdawgbeav Posted May 7, 2018 Share Posted May 7, 2018 This is going to seem like an odd question, but would anyone be able to measure the width of their XDM trigger guard? I am looking to do a comparison to another polymer pistol and since I don't have an XDM, I can't take a set of calipers to it. I imagine most of the guards are going to be about the same, but a 5.25 would be nice. Thank you. Link to comment Share on other sites More sharing options...
Sarge Posted May 7, 2018 Share Posted May 7, 2018 .594-.595 depending on exactly where you measure it. 5.25 XDM 9mm Link to comment Share on other sites More sharing options...
bigdawgbeav Posted May 7, 2018 Author Share Posted May 7, 2018 (edited) Just looking at the front of the trigger guard, the part that would click into a holster. And thank you. Edited May 7, 2018 by bigdawgbeav Link to comment Share on other sites More sharing options...
Sarge Posted May 7, 2018 Share Posted May 7, 2018 14 minutes ago, bigdawgbeav said: Just looking at the front of the trigger guard, the part that would click into a holster. And thank you. Ok .5945-.595 depending on how hard I squeezed the calipers. Link to comment Share on other sites More sharing options...
dsu96 Posted May 9, 2018 Share Posted May 9, 2018 Same as Sarge...mine was on a .40 Link to comment Share on other sites More sharing options...
bigdawgbeav Posted May 10, 2018 Author Share Posted May 10, 2018 That is really close to what I was looking for. I have the Canik TP9 SFx and looking for a race holster insert for it. I measured the width at 0.58"... The XDM insert might be better than the Walther as that is pushing 0.6 in the width. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now