Jump to content
Brian Enos's Forums... Maku mozo!

Grand Power X-Cal, K100 Red Dot Milling


Recommended Posts

44 minutes ago, Bonusfrag said:

The service is listed in their website. $125 + additional shipping insurance if you want it. Pretty reasonable. 

Thanks.  Did you have them re-coat the milled area or leave it raw?

Link to comment
Share on other sites

  • 5 months later...

I had my K100 done by Patriot Defense and I couldn't be happier. Well-priced, quick turnaround, and even called to let me know that they couldn't sink the sight as far as they'd like due to the firing pin block and made sure I was okay with that. They still got it pretty darn deep, lol.

 

51407661522_825a4b1e2d_b.jpg

 

51409167669_c5158bd35d_b.jpg

 

The irons are suppressor sights from a CZ P10. I measured the dovetails and these were the closest; I had to file the front sight and add a channel for the retaining pin, and then shim the rear sight to get pressure on the dovetail cut. So far, so good.

 

The magazine extension is a Taylor Freelance, the grip tape is from Springer, and the light is from China and totally isn't real (but works well enough) :D .

Edited by matteekay
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...