tomjerry1 Posted April 17, 2018 Share Posted April 17, 2018 Anyone had any luck drilling a mag release for a mag extension? I can not find one for a Caspian? Link to comment Share on other sites More sharing options...
Don_B Posted April 17, 2018 Share Posted April 17, 2018 From my experience trying that if you are lucky enough to get it drilled, you will probably ruin the drill bit, you will break the tap in it. Did that a couple times and gave up. The mag release is very hard. Link to comment Share on other sites More sharing options...
drewbeck Posted April 17, 2018 Share Posted April 17, 2018 My experience showed that drilling was easy but tapping needs extreme caution. I snapped a tap off which basically makes the release worthless because it’s almost impossible to get that tap out or drill and tap a bigger size. its doable just be cautious with the tap unless you’ve done much 4-40, 5-40 tapping Link to comment Share on other sites More sharing options...
drewbeck Posted April 17, 2018 Share Posted April 17, 2018 1 minute ago, Don_B said: From my experience trying that if you are lucky enough to get it drilled, you will probably ruin the drill bit, you will break the tap in it. Did that a couple times and gave up. The mag release is very hard. Good to know my experience is similar! Link to comment Share on other sites More sharing options...
manolis Posted April 17, 2018 Share Posted April 17, 2018 I have found big success when tempered the mag release (red colour or orange , it is not immportant), let it cool without hurry and then drilled .After that tapping is easy. Link to comment Share on other sites More sharing options...
tomjerry1 Posted April 17, 2018 Author Share Posted April 17, 2018 Thank you for the response, time for the torch! Link to comment Share on other sites More sharing options...
stardust tommy Posted April 19, 2018 Share Posted April 19, 2018 that is how I drill and tap S&W revolver triggers. I put the trigger between copper blocks in the vise and just heat the part that needs to be tempered. The copper keeps the heat away from parts that need to be realy hard gr T Link to comment Share on other sites More sharing options...
Tripod Posted May 2, 2018 Share Posted May 2, 2018 Glad to read others had trouble taping mag releases. Unbelievable how hard the metal in these things are. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now