Jump to content
Brian Enos's Forums... Maku mozo!

EAA Tanfoglio Limited trigger install


Ryanjg

Recommended Posts

I installed a Henning trigger and extended firing pin and polished internals keep in mind this is only the 2nd time I've attempted trigger work and the other being a CZ. I have a dumb question everything works great with mag out if I insert an empty mag the slide release moves and and causes a bind when I rack the slide. Is this normal I haven't loaded the magazine yet with live rounds can't get to a range for a few days and don't have any dummy rounds. 

Link to comment
Share on other sites

When I pulled the slide you can watch the slide release tilt up on the outside of the frame if you pull hard enough you can get the slide to go all the way back and then when the side comes forward it doesn't go all the way forward just likes a little but you can push it forward all of this with an empty magazine .  If I could go shoot the gun in a few days I would to test it's just bothering me not knowing if all is good.  I guess I've never pulled the slide back with an empty magazine on this gun before.

Link to comment
Share on other sites

I read your post I did remove the mag release during installation of trigger and put it back in on same side if I put pressure on the top back of the slide release it won't tilt up.  If this is normal for this gun I'm fine with it just was trying to trouble shoot

Link to comment
Share on other sites

Johnbu yes I own a lot if pistols just trying to figure out why my slide release is moving when I rack the slide on an empty magazine. The rear of the release on the outside of the frame actually goes up on the outside of the slide when pulling back only with an empty magazine

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...