Ryanjg Posted January 15, 2017 Share Posted January 15, 2017 (edited) I just installed the Henning flat trigger and polished my internals. All went well I am now wanting to remove the firing pin block but wasn't for sure on what to do besides remove the firing pin plunger and spring. I also installed the xl firing pin. Edited January 15, 2017 by Ryanjg Mis spelled word Link to comment Share on other sites More sharing options...
MemphisMechanic Posted January 15, 2017 Share Posted January 15, 2017 You'll get more traffic in the Tanfoglio forum: http://forums.brianenos.com/index.php?/forum/202-eaatanfoglio/ Link to comment Share on other sites More sharing options...
BeerBaron Posted January 15, 2017 Share Posted January 15, 2017 Literally just need to remove the plunger/block and the little spring. That's it. Link to comment Share on other sites More sharing options...
Ryanjg Posted January 15, 2017 Author Share Posted January 15, 2017 Thanks I didn't know if I had to do anything to the sear or not. Link to comment Share on other sites More sharing options...
BeerBaron Posted January 16, 2017 Share Posted January 16, 2017 nope, there is a little 'bump' on the side of the sear (or some have the 2 piece sear) which pushes on the firing pin block. the 2 piece sear has that 'leg/bump' as a separate piece but there's no need to remove it unless you want to replace it with a 1 piece sear. Link to comment Share on other sites More sharing options...
Ryanjg Posted January 16, 2017 Author Share Posted January 16, 2017 Thanks Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now