Jump to content
Brian Enos's Forums... Maku mozo!
Nick S

Mystery Part From M2 Trigger Group

Recommended Posts

I tore down my trigger group from my TTI M2 and after reassembly this was left over. To clarify I'm referring to the piece above the safety plunger.

image_zpslh5draio.jpeg

I disassembled it again and went through to make sure I didn't miss anything. I checked the schematic and nothing. It is the same diameter as as safety plunger so was thinking it may go in there but not sure of the purpose?

Any ideas?

Thanks.

Edited by Nick S

Share this post


Link to post
Share on other sites

It is an over travel device that TTI uses to limit trigger over travel. It goes around the pin that goes through the back of the trigger housing where the little square cut out at the back of the trigger rides. It is kind of a bitch to install, but that is where it goes.

Share this post


Link to post
Share on other sites

All part of the extensive knowledge of the Benelli system at your finger tips! RNT baby!!!!

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...