My rookie Stock 2 trigger job

[CAB33]

Brand new Stock 2

Titan hammer

one piece sear

13lb wolf hammer spring

SA = 4lb

DA = ? my gauge only goes to 8lb

What am I missing to make it better?

[sfinney]

Never mind.

Edited May 3, 2016 by sfinney

[CAB33]

Polish the hammer spring strut bar.

Polish the plunger strut and clean up the inside of the wedge. Polish the wedge, as well.

Polish the trigger bar.

Polish the sides of the hammer.

Put a CGW sear spring in.

Polish the sear contact points.

Is this the correct CGW sear spring?

https://cajungunworks.com/product/12-sear-spring/

[CAB33]

Thanks.

What are the things that help reduce the DA pull?

[johnbu]

And cgw reduced trigger return spring.

I polished probably 6+ times. Especially pins, inside holes and such.

On your DA question;

I found polishing and adjusting spring tension. Clipping coils on the hammer spring. Oddly a clipped 14 gave lower pull than a clipped 13.

Edited May 3, 2016 by johnbu