Jump to content
Brian Enos's Forums... Maku mozo!
jid2

CFD Comp - Cone version using an EGW Blank

Recommended Posts

Had someone supply an EGW cone comp blank to cut ports into. Just finished up and it came out really nice. I had to shorten the last port by about .10" to fit it into the EGW blank. So not exactly the same as the regular version, but pretty close.

I have no desire to make a Ti cone version, so this is a nice option. If you want one like this it's possible I'll build them to order or maybe run a handful and stock them. We'll see.

20150712_142434.jpg

20150712_142450.jpg

Edited by jid2

Share this post


Link to post
Share on other sites
Guest

Yeah, I like that! :cheers:

I can see that hanging on the end of a 5" skinny barrel with the slide length cut back to match. Hmmmmmm......

How much does it weigh?

Share this post


Link to post
Share on other sites

A Trubore barrel? Grab some measurements and we can see how it fits.

Share this post


Link to post
Share on other sites

Ok I'll look into it. I'm not sure what the surface area is on the blank. Once I get some more info I'll let you know.

Share this post


Link to post
Share on other sites

Same as EGW blank. So it would fit, just need to make the last port a little smaller.

Share this post


Link to post
Share on other sites

Ok good to know. I may just get a kkm barrel and go from there. No special order needed.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...