TPMINAZ Posted December 17, 2014 Share Posted December 17, 2014 The pin in the front of the rear sight broke. This is a small pin with a small indent. Springfield sent a new pin but it's not going in as expected. (Great customer service by the way.) This pin has the small indent i mentioned so I am thinking that is part of the problem. Does anyone know a trick or procedure to get this new pin in? Link to comment Share on other sites More sharing options...
Loves2Shoot Posted December 18, 2014 Share Posted December 18, 2014 It is easier if you make a slave pin. I use a roll pin instead of the factory pin. Link to comment Share on other sites More sharing options...
Out of Ammo Posted December 29, 2014 Share Posted December 29, 2014 I agree with the idea of the slave pin. I tried to use the factory pin, but had a difficult time getting the pin in. I used a roll pin from the hardware store and it worked much better. Link to comment Share on other sites More sharing options...
DagoRed Posted January 1, 2015 Share Posted January 1, 2015 What size roll pin? I have an XDm I haven't shot yet, would like to put this in the knowledge/reference bank Thanks Red Link to comment Share on other sites More sharing options...
texasref Posted January 1, 2015 Share Posted January 1, 2015 You said the pin broke, but did you get it out? If not that may be whats keeping you from getting the new one in. Just take the replacement pin with you and get the appropriate size roll pin. By their design they work much better. Link to comment Share on other sites More sharing options...
Out of Ammo Posted January 3, 2015 Share Posted January 3, 2015 The pin is 1.98mm or 5/64. It's 3/4" long. Link to comment Share on other sites More sharing options...
moonshoxx Posted December 9, 2019 Share Posted December 9, 2019 Guys sorry to dredge this back up but I am going back to Production from Carry Optics sooooooo i need to put the factory sight pin back in. Has anyone figured this out yet (as in tricks or anything to make it easier. Scott, when you said you used a 5/64 roll pin, did you just get one and hammer it in with a punch. Does the sight hold a zero well like this. Thanks and sorry for the ignorace. Link to comment Share on other sites More sharing options...
Out of Ammo Posted December 19, 2019 Share Posted December 19, 2019 There's a video on replacing or installing the rear site on the XDM on YouTube. Link to comment Share on other sites More sharing options...
Dyoung1987 Posted December 23, 2019 Share Posted December 23, 2019 Here is a helpful video if you haven't already found it. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now