encoreman Posted February 2, 2014 Share Posted February 2, 2014 Hi guys I have shot this Para 10-15K and have done nothing but change out 2 firing pins stops that were cracked. It has always ran smooth. Last match I thought it was my cast lead reloads on 2 stages the slide wouldn't go completely into battery and I had to hold slide with left hand and hit back of grip hard with the right hand to get it to slide and eject round. Well today I was cleaning a couple of pistols and when I went to put this Para back together I had the same problem, I was putting in the slide stop pin and the slide would be smooth as glass and then it wouldn't budge, I messed with it some couldn't find anything that seemed out of place. I always run this gun wet and there was plenty of lube, after I put it back together it seemed fine, but I think now it wasn't the ammo. Any ideas before the gunsmith gets to earn his keep? Thanks Mac Quote Link to comment Share on other sites More sharing options...
ParaGunner Posted February 2, 2014 Share Posted February 2, 2014 Check the barrel link,recoil assembly,barrel hood/feet and barrel bushing. Take it apart and reassemble piece by piece testing each piece until you find what part is causing the bind. Quote Link to comment Share on other sites More sharing options...
SSGJohnV Posted February 27, 2014 Share Posted February 27, 2014 What ParaGunner said. I think I remember having a similar problem, but I can't be sure. Worst case scenario is a new slide stop if it is the problem, so at least its a cheap part. *shrug* Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.