Cases are misaligned not fitting into shellplate

[Sandro]

I got a 1050 last month, have some issue with the CCI primers and now every 3 strokes I get case not fitting in the shellplate. It is driving me nuts.

I walked way from it tonight. I am going to clean it good, lubricate everything tomorrow. The bummer is that I don't remembers having same problems with a 650 when I use to have one eight years ago.

Anybody here had the same issues?

[Action Pistolero]

I have the same problem. I make sure that the shellplate is clean. Also, be sure that the thing that pushes the case in the shellplate is clean and has no left over media jammed in it. Be sure to lubricate it after cleaning. That seems to be critical. Mine used to do it often before I started doing this and now I still get a few every thousand rounds.

Good luck.

Kevin

[TRG65]

when I had a similar problem, the case rim on my 9's jamming as they were being fed, I found the shell plate was at the incorrect height. I had to tighten down my shellplate just a smidge, which shifted the lower edge of the shellplate lower lining it up below the path the case rim was taking. Problem disappeared.

I had never noticed this issue on my 650 either, which I used for 9mm 'til the 1050 came along now the 650 is loading .223. A 650 is a different animal than the 1050.

Good luck

[D.Hayden]

when I had a similar problem, the case rim on my 9's jamming as they were being fed, I found the shell plate was at the incorrect height. I had to tighten down my shellplate just a smidge, which shifted the lower edge of the shellplate lower lining it up below the path the case rim was taking. Problem disappeared.

Ditto for me... for 40S&W

[Sandro]

Thanks guys, I think my shellplate is too high. I was so mad last nite that I had to walk way from the D#$%# thing.